The MPJ Miniature Panel Jack requires less than half of the panel area required by the Standard Size connectors. A simple push-on clip is all that is required to retain the connector in a rectangular cutout, or the optional MSS snap strip can be used to mount a row. Angled terminal screws allow wiring to be done after panel assembly.
8.1 x 16.7 mm (0.32 x 0.66)" Cutout Required
14.3 mm (0.56") Centers Horizontally
23.8 mm (0.94") Centers Row to Row Minimum.
† All prices on this site are shown in Malaysian Ringgit. Ordering Example: (1) MPJ-K-F Female miniture panel jack with type K calibration, MYR13.50 plus (1) MPJ-T-F Female miniture panel jack with type T calibration, MYR13.50, MYR13.50 + 13.50 = MYR27.00
Calibration Type select from: K for Type K Calibration T for Type T Calibration J for Type J Calibration E for Type E Calibration R/S for Type R/S Calibration G for Type G Calibration C for Type C Calibration D for Type D Calibration U for Type U Calibration N for Type N Calibration
ROHS select from: Nothing(leave field blank) for Non-ROHS -ROHS for ROHS
Note: All combinations may not be valid, check spec sheet for valid part numbers.