HBM Strain Gauges | High Temperature Strain Gauges | OMEGA
† All prices on this site are shown in Philippine Pesos.
Note: † Maximum permitted effective excitation voltage specified for steel material.
Instructions for Use of Accessories shown under Product Manuals below.
All listed adhesives are specifically designed/approved to be used for the new M Series of strain gauges.
Safety Data Sheets for Accessories can be found (without "1-" Part Number prefix) at omega.com, Support, MSDS.
Geometries select from:LM1
for Linear strain gage with one measurement gridTM1
for Stacked T rosette with two measurement gridsXM4
for V-shaped strain gage with two measurement gridsRM8
for Rectangular strain gage rosette with three measurement gridsRM9
for Stacked strain gage rosette with three measurement grids
Measurement Grid mm(inch) select from:1.5
for Measurement Grid A 1.5 (0.06)3
for Measurement Grid A 3 (0.12)6
for Measurement Grid A 6 (0.24)
Note: All combinations may not be valid, check spec sheet for valid part numbers.
Rapid Adhesive (English/German/French)
Two-component Epoxy resin adhesive (English/German/French)
Accelerator for Z70 adhesive (English/German/French)