PHE-5460 and ORE-5460
Flat Surface In Line pH/ORP Electrodes
† All prices on this site are shown in Taiwan Dollars.
Note: Comes complete with Electrode Care Instruction Sheet.
Temperature compensation is not required with ORP electrodes.
Electrodes must be mounted vertically and kept moist.
Order electrode and mounting assemblies separately. Materials of construction must be the same.
* Since April 2010 the cap on the mounting assembly was extended 1/4 of an inch, 1/2 NPT threads added for use when attaching cap to threaded conduit, and grip dimples were added for ease of use.
For 5% HF application, add suffix "-HF" to electrode model number, add $50 to price.
For low conductivity application, add suffix "-LC" to electrode model number, add $30 to price.
For ground loop interrupt Circuit, add suffix "-GL" to electrode model number, add $158 to price.
Mounting assemblies supplied with 3 m (10') of cable with BNC connector.
For non-standard cable lengths up to 15 m (50') replace the suffix "-10" in the model number with the desired length in feet, add $2 per foot to price. (Additional cost of $2 per foot applies to entire cable length).
Ordering Example: (1) PHE-5460 Electrode, TWD6,570 plus (1) PHEH-54-10 Mounting Assembly, TWD3,605, TWD6,570 + 3,605 = TWD10,175
NPT select from:Nothing(leave field blank)
for 3/4 in. NPT-1
for 1 in. NPT-2
for 2 in. NPT
ATC Sensor select from:Nothing(leave field blank)
-PT100 for 100 ohm platinum RTD
-PT1K for 1000 ohm platinum RTD
-R3K for 3000 ohm Balco
-300 for 300 ohm Thermistor
-TH700 for 700 Series Thermistor
Note: All combinations may not be valid, check spec sheet for valid part numbers.